Presser-Foot Fixation - Bernina B 590 Service And Maintenance Manual

5.3.2 Presser-foot fixation

Check:
• Use a new presser foot to check if clamping lever a meshes with clamping bar b by a third to a half.
• The presser foot sole and the markings on the stitch plate must be parallel.
Adjustment:
• Untighten screw c (T20) on clamp d.
• Adjust clamp height until correct clamping position is reached
(one third of clmaping span). Ensure that presser foot and
stitch plate are parallel.
• Retighten screw c.
• Recheck that presser foot and stitch plate are parallel.
o Sewing-/embroidery machines - Presser-foot sole and stitch
plate must be parallel.
o Embroidery machines - Stitch hole in embroidery foot 26 and
stitch hole in stitch plate
must be centred.
BERNINA International AG Seestrasse 161 CH-8266 Steckborn
DRAFT – VERSION
c
d
a
b
Schweiz Seite 91 von 172