Needle Height Without Basting Device - Bernina B 590 Service And Maintenance Manual

5.5.5.1 Needle height without basting device

Check:
•
See 5.5.5
Adjustment:
• Remove head cover (see 4.1.1)
• Bring needle bar to BDC (Bottom Dead Centre).
• Untighten needle-bar clamp screw.
• Place distance plate b (730475.51.00) under distance gauge a on stitch plate.
• The needle bar represents 'target' c and must be set to level 2 of distance plate b.
• Retighten needle-bar clamp screw.
• Check functioning of threader (see 5.9)
• Refit heas cover (if appropriate).
BERNINA International AG Seestrasse 161 CH-8266 Steckborn
DRAFT – VERSION
Schweiz Seite 100 von 172