5.2 Head-frame plate position
Important!
In order to avoid any damage at all, the following settings up to and including item 5.3.2
shall be carried out without sewing needle(see 4.3.2)!
5.2.1 Position of head-frame plate/stitch plate in Y-
direction
5.2.1 Position of head-frame plate/stitch plate in Y-
direction
Check embroidery machine (pict. A):
• Remove needle.
• Attach stitch plate.
• Attach presser foot 26.
• Lower presser foot.
• Set needle bar to BDC.
• The distance between presser foot and stitch hole
must be the same at tip and end of foot.
Check sewing-/embroidery machine (pict. B):
• Remove needle.
• Attach stitch plate.
• Attach presser foot 1 or 1C.
• Lower presser foot.
• The distance between presser foot and stitch hole
must be the same at tip and end of foot.
Note:
This setting affects (5.5.3 needle-/hook distance)
Adjustment:
• Raise presser foot ca. 1mm from stitch plate.
• Use screw d (T20 M4x16) to set distance:
o Turning it clockwise moves the foot forward.
o Turning it counterclockwise moves the foot backward.
BERNINA International AG
Seestrasse 161
CH-8266 Steckborn
DRAFT – VERSION
A
Dist.
=
B
Dist.
=
Schweiz
d
Seite 88 von 172