Changing The Turn Signal Bulb (All Eu Models) - Husqvarna FE 450 EU 2020 Owner's Manual

15 ELECTRICAL SYSTEM
15.9
Note
Damage to reflector Grease on the reflector reduces the light intensity.
Grease on the bulb will evaporate due to the heat and be deposited on the reflector.
–
Clean and degrease the bulbs before mounting.
–
Do not touch the bulbs with your bare hands.
118
H03753-10
H03754-10

Changing the turn signal bulb (All EU models)

E00360-10
Main work
–
1
Turn protection cap together with the underlying bulb
socket counterclockwise all the way and remove it.
–
2
Pull bulb socket of the position light out of the reflector.
–
3
Pull out headlight bulb
–
Insert the new headlight bulb.
Headlight (HS1 / Sockel PX43t) (
–
Insert the protection cap with the bulb socket into the reflec-
tor and turn it clockwise all the way.
–
4
Ensure that O-ring is seated properly.
–
Insert the bulb socket of the position light into the reflector.
Finishing work
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
Main work
–
Remove the screw on the rear of the turn signal housing.
–
Carefully remove turn signal glass
–
Lightly squeeze orange cap
and take it off.
–
Press the turn signal bulb lightly into the socket, turn it coun-
terclockwise by about 30°, and pull it out of the socket.
Info
Do not touch the reflector with your fingers and keep it
free from grease.
–
Press the new turn signal bulb carefully into the socket and
turn it clockwise until it stops.
Turn signal (R10W / socket BA15s) (
–
Mount the orange cap.
–
Position the turn signal glass.
.
p. 149)
p. 116)
p. 119)
1
.
2
in the area of the holding lugs
p. 149)