Table of Contents
Advertisement
Antenna/Cable and TV/Monitor Connection
Connecting a TV/Coler Monitor Fauipped
with Audio/Video Inputs &
a:
Signal flow
50
With the following connection the picture and sound
quality will be better than that when the TV is connected
only to the VHF/UHF OUT terminal on the VCR.
4 Connect the antenna cable to VHF/UHF IN on the
VCR.
2 Connect the VHF/UHF OUT to your TV.
This connection is not required for a color monitor.
3 Connect LINE OUT 1 S VIDEO to the S VIDEO input
on the TVi/color monitor with the supplied S VIDEO
connecting cord.
4 Connect LINE OUT 1 AUDIO to the audio inputs on
the TV/color monitor with the supplied audio
connecting cord.
To watch the playback picture
Select the TV/VTR input selector on the TV to VTR.
Check ANTENNA SW inside the upper compartment
after connecting the antenna.
If you connect a TV not equipped with audio/video
inputs
Set to AUTO.
* To watch the playback picture, simply press B PLAY.
When set to MANUAL, you have to press TV/VTR so
that the VTR indicator is displayed.
{f you connect a TV equipped with audio/video inputs
Set to MANUAL.
* To watch a TV program, simply select the channel on
the TV. When set to AUTO, you have to press TV/VTR
so that the VTR indicator disappears.
Notes
e With this connection, the TV/VTR button on this unit
does not function.
¢ With a color monitor, you cannot watch one TV program
while recording another.
* Keep the audio/video connecting cords away from the
antenna cable, otherwise the picture may be affected.
When a TV/monitor is not equipped with the S VIDEO input
connector
Connect LINE OUT 1 (or 2) VIDEO to the video input jack
on the TV/monitor with the supplied video connecting cord.
Advertisement
Table of Contents
