Table of Contents
Advertisement
42
You can use the buttons on the VCR with the same
name or mark as those on the Commander.
Before operating
¢ Hi E] switch: AUTO
® PCM MODE selector: NORM
e AUDIO MONITOR selector: PCM
Press OPEN/CLOSE and insert a cassette.
Press OPEN/CLOSE again to close the cassette
holder.
2 Tum on the TV and select the input for the
VCR.
For the TV without video/audio Inputs, select the
channel (8CH or 4CH) for the VCR.
3 Press m PLAY. Playback will begin.
The indicator on the @ PLAY button on the VCR will
light during playback.
If playback does oot start
Readjust the channel for the VCR on the TV. (See page 52.)
(D-2]
To stop playback
Press m STOP.
To advance the tape rapidly | Press mp FF.
To rewind the tape
Press <q REW.
To play back a tape from the}
On the Remote Commander:
beginning after rewinding
Press AUTO PB,
— Auto play
On the VCR: Press t PLAY
'
keeping <4 REW.
When the tape reaches the end during playback
It will be automatically rewound. The power will remain
on.
'Picture adjustment:
Turn the SHARPNESS control toward SHARP to get a
sharp picture or toward SOFT for a soft picture.
If the playback picture does not appear
Check the DIGITAL MULTI PLAY selector at the rear. Set
the selector to AUTO.
If the playback picture does not appear when the recorier
is connected to a TV without video/audio inputs
Set ANTENNA SW inside the upper compartment of the
VCR to AUTO. When the selector is set to MANUAL, prss
TVIVTR on the Commander or the recorder so that the VFR
indicator in the display window lights.
j
3 3
3
Advertisement
Table of Contents
