Table of Contents
Advertisement
-Erasing Index Signals 'Rea.
2°
Index signals in sequence -
1 Press INDEX once.
Erasing while 'index 'scanning —'To erase the.
2 Press << REW to rewind the tape or mB» FF to
rapidly advance it.
Each time an index signal is detected, the tape will
be played back for approximately 10 seconds and
then rewound or rapidly advanced.
3 Approximately two seconds after playback has started
by the index signal to be erased, press INDEX ERASE.
After the erasure, index scan will resume.
At each index signal to be erased, press INDEX
ERASE.
To stop index scanning, press mg STOP.
Erasing while Index search — To erase a
particular index signal
4 Press INDF™ repeatedly until the number of the index
Signa to be erased is displayed.
2 Press <q REW or pp FF.
The tape will be rewound or rapidly advanced until the
designated index signat is located, and playback will
begin.
3 Approximately two seconds after, press INDEX
ERASE.
' After the erasure, normal playback will begin.
Notes
¢ INDEX ERASE should be pressed within approximately
410 seconds after playback starts.
* The index 'signa! cannot be erased if it is recorded on a
portion where the recording tape speed has been
changed.
¢ During erasing index signals, a black noise band will
appear at the bottom of the picture and the sound will
be lowered. However, this does not affect audio/video
recording signals on the tape.
35
Advertisement
Table of Contents
