Table of Contents
Advertisement
"Antenna/Cable and TV/Monitor Connection -
Re?
"How to attach an-F-type confiector:[F-7/ |
Z
1 Strip the cable covering to expose the center
1
;
conductor.
2 Pass the ring over the cable and fold back the shield.
7 mm ('% inch) 10mm is inch)
Insert the inner conductor into the F-type connecior.
2 ——C-$--D
3 Crimp the ring to hold the conductor in place.
'
4 Connect to the VHF/UHF IN connector.
3
3mm ('/s inch)
.
How to attach an antenna connector [R-3]
4 Wrap the wires of a 300-ohm twin lead-in around the —
posts and tighten the screws.
2 Connect to the VHF/UHF IN connector.
How to attach an EAC-66 U/V band pci
(mixer (R53)
4 Wrap the wires of a 200-ohm twin lead-in around the
VHF
posts and tighten the screws.
"UHF
VHF/UHF IN
. 3
4
2 Plug the F-type connector of the VHF antenna cable
into the separator.
3 Connect to the VHF/UHF IN connector.
Caution
Connections between the recorder VHF/UHF OUT
connector and the antenna terminals of a TV receiver
should be made only as shown in these instructions.
Failure to do so may result in operation that violates
the regulations of the Federal Communications
Commission regarding the use and operation of rf
devices,
Never connect the output of the recorder to an antenna
or make simultaneous (parallel) antenna and recorder
connections at the antenna terminals of your TV.
48
Advertisement
Table of Contents
