Auto Take-Off And Auto Landing; Starting/Stopping The Motors - dji Inspire 2 Series User Manual

INSPIRE 2 SERIES User Manual

Auto Take-off and Auto Landing

Auto Takeoff
Use auto takeoff only if the Aircraft Status Indicators are blinking green. Follow the steps below to
use the auto takeoff feature:
1. Launch the DJI GO 4 app, and enter "Camera" page.
2. Complete all steps on the pre-flight checklist.
3. Tap" ", and confirm that conditions are safe for flight. Slide the icon to confirm and takeoff.
4. Aircraft takes off and hovers at (1.2 meters) above ground.
Aircraft Status Indicator blinks rapidly when it is using the Vision System for stabilization.
The aircraft will automatically hover below 10 meters. It is recommended to wait until there
is sufficient GPS lock before using the Auto Take-off feature.
Auto-Landing
Use auto-landing only if the Aircraft Status Indicator is blinking green. Follow the steps below to use
the auto-landing feature:
1. Tap on , to ensure the landing condition is ideal. Slide to confirm.
2. Abort landing process immediately by using the
3. a. When Landing Protection determines that the ground is suitable for landing, the Inspire 2 will
land gently.
b. If Landing Protection determines that the ground is not suitable for landing, the Inspire 2 will
hover and wait for pilot confirmation.
c. If Landing Protection is not operational, the DJI GO 4 app will display a landing prompt when
the Inspire 2 descends below 0.7 meters. Pull down on the throttle or use the auto landing
slider to land.
4. Aircraft will land and turn off automatically.

Starting/Stopping the Motors

Starting Motors
A Combination Stick Command (CSC) is used to start the motors. Push both sticks to the bottom in-
ner or outer corners to start the motors. Once the motors have started spinning, release both sticks
simultaneously.
Stopping the Motors
There are two methods to stop the motors.
Method 1: When Inspire 2 has landed, push the left stick down
was used to start the motors, as described above
sticks once motors stop.
©
64
2018 DJI All Rights Reserved.
button on the screen.
OR
, then conduct the same CSC that
. Motors will stop immediately. Release both