Starting/Stopping The Motors; Flight Test - dji MINI 3 PRO User Manual

DJI Mini 3 Pro User Manual

Starting/Stopping the Motors

Starting the Motors
Perform the Combination Stick Command (CSC) as shown below to start the motors. Once the motors
have started spinning, release both sticks simultaneously.
Stopping the Motors
The motors can be stopped in two ways:
Method 1: When the aircraft has landed, push the throttle stick down and hold. The motors will stop
after three seconds.
Method 2: When the aircraft has landed, push the throttle stick down, and perform the same CSC used
to start the motors. Release both sticks once the motors have stopped.
Method 1
Stopping the Motors Mid-Flight
Stopping the motors mid-flight will cause the aircraft to crash. DO NOT stop the motors mid-flight
unless you encounter an emergency situation, for example, if a collision has occurred, or if the
aircraft is out of control and ascending or descending quickly, or the aircraft is rolling in the air. To
stop the motors mid-flight, perform the same CSC used to start the motors. The default setting
can be changed in DJI Fly.

Flight Test

Takeoff/Landing Procedures
1. Place the aircraft in an open, flat area with the rear of the aircraft facing towards you.
2. Power on the remote controller and the aircraft.
3. Launch DJI Fly and enter the camera view.
4. Wait for the aircraft self-diagnostics to complete. If DJI Fly does not show any irregular warning, you
can start the motors.
5. Push the throttle stick up slowly to take off.
6. To land, hover over a level surface and gently push the throttle stick down to descend.
©
62 2022 DJI All Rights Reserved.
OR
OR
Method 2