Starting/Stopping The Motors; Flight Test - dji Mavic Pro User Manual

Hide thumbs Also See for Mavic Pro:

Table of Contents

Mavic Pro User Manual

Starting/Stopping the Motors

Starting the Motors

A Combination Stick Command (CSC) is used to start the motors. Push both sticks to the bottom

inner or outer corners to start the motors. Once the motors have started spinning, release both sticks

simultaneously.

Stopping the Motors

There are two methods to stop the motors.

Method 1: When Mavic Pro has landed, push the left stick down , then conduct the same CSC that was

used to start the motors, as described above

motors stop.

Method 2: When the aircraft has landed, push and hold the left stick down. The motors will stop after three

seconds.

Stop Motors Mid-flight

Stop motors mid-flight will cause the aircraft to crash. The motors can only be stopped mid-flight when the

flight controller detects a critical error. (This setting can be changed in the DJI GO 4 app)

Takeoff/Landing Procedures

1. Place the aircraft in an open, flat area with the battery level indicators facing towards you.

2. Turn on the remote controller and your mobile device, then turn on the Intelligent Flight Battery.

3. Launch the DJI GO 4 app and enter the Camera page.

4. Wait until the Aircraft Indicator blinks green. This means the Home Point is recorded and it is now safe

to fly. If they flash yellow, the Home Point has not been recorded.

5. Push the left stick up slowly to take off or use Auto Takeoff.

6. Shoot photos and videos using the DJI GO 4 app.

7. Pull down the left stick to descend, the aircraft will hover at 1.5 ft (0.5 m) above the ground for about 1

second, then hold the left stick at its lowest position until you touch the ground and the motors stop.

8. Turn off the Intelligent Flight Battery first, then the Remote Controller.

. Motors will stop immediately. Release both sticks once

Method 1

Method 2

Table of Contents