Pic.12 Loading The Ribbon 1; Pic.13 Loading The Ribbon 2; Pic.14 Installing The Cleaning Roller; Pic.15 Peeling The Protective Wrapper - idp SMART-50 Instruction Manual

Pic.12 Loading the ribbon 1

①
②

Pic.13 Loading the ribbon 2

Pic.14 Installing the cleaning roller

Pic.15 Peeling the protective wrapper

2.1.4. Install a ribbon into the ribbon
2.1.5. Insert the supply side of the ribbon
③
④
2.1.6. Install the disposable cleaning
2.1.7. Peel the protective wrapper from
16
cartridge as left Pic. 11.
to no.1 hole and press the opposite
(no.2). Insert the take-up side of the
ribbon same method to no.3 and
no.4. After inserting, tighten the
ribbon.
(Caution! If the ribbon is not tightened, a
rolling up error might be happened.)
roller to the ribbon cartridge.
the cleaning roller.
After removing the protective wrapper, the
cleaning roller should be kept clean from
fingerprints, dust and foreign substances to
avoid contamination because it is adhesive.
(Caution! Do not use without peeling off the
protective wrapper because the cleaning
roller cannot perform its function.)