Table of Contents
Advertisement
PREPARE HOOD
1
2
3
Slot non-return valves into the adapter
and ensure they move freely when
installed.
Fit the duct adapter to the rangehood
using two supplied Phillips screws.
Unclip filters to remove.
INSTALL HOOD
1
2
3
4
Install the 30mm upper hood
mounting screws* as per the product
dimension page. Ensure both screws
protrude 2mm.
Lift the rangehood and slot onto the
two upper hood mounting screws.
Drill and secure the two supplied*
lower attachment screws through the
holes underneath the rangehood.
Level the front and side of the
rangehood and adjust the two
supplied lower attachment screws.
Tighten the two upper attachment
screws.
If the wall is uneven, loosen
lower screws and install packers to
level the rangehood to wall.
*Use plastic wall plugs as required.
19
Advertisement
Table of Contents
