Removing The Engine Guard (Sx-F Cairoli Replica); Installing The Engine Guard (Sx-F Cairoli Replica) - KTM 350 SX-F Owner's Manual
Hide thumbs
Also See for 350 SX-F:
- Owner's manual (151 pages) ,
- Setup instructions (28 pages) ,
- Setup instructions (30 pages)
Table of Contents
Advertisement
SERVICE WORK ON THE CHASSIS
Removing the engine guard (SX‑F CAIROLI REPLICA)
10.48
Installing the engine guard (SX‑F CAIROLI REPLICA)
10.49
–
Inject the liquid into the system until it escapes from hole
without bubbles.
–
To prevent overflow, drain fluid occasionally from the master cylinder reservoir.
–
Remove the bleeding syringe. Mount and tighten screws bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container rim
–
Position the cover with the membrane. Mount and tighten the screws.
B00042-10
–
Remove screws
B00597-10
–
Attach the engine guard on the frame at the rear and swing up at the front.
–
Position the holding bracket. Mount and tighten the screws.
Guideline
Remaining screws, chassis
B00598-01
4 mm (0.16 in)
and the holding bracket. Remove the engine guard.
1
M6
53
of the master cylinder
6
10 Nm (7.4 lbf ft)
Hide quick links:
Advertisement
Table of Contents
