Last Steps Before Leaving The System - Environmental Water Systems EWS-SPECTRUM-V2 Product And Installation Manual

check the drain water and put system in service
OBSeRVe THe DRAIN WATeR DURING CYCLe 2. RINSe
16.
IF THe WATeR IS RUNNING CLeAR - PROCeeD TO STeP #17.
IF THe WATeR ReMAINS GReY
BeGIN ANOTHeR SYSTeM FLUSH
Press the REGEN button once.
REGEN TODAY will flash on the display.
Press and hold the REGEN button for three seconds
until the valve regeneration initiates.
The backwash is about to begin
Repeat the flushing sequence until the water from the drain line runs clear.
open outlet for service and go through a checklist to avoid any issues
OPeN OUTLeT ON THe BYPASS
17.
TO PUT THe SYSTeM IN FINAL SeRVICe POSITION
Do not put system into service until proper installation, setup, clearing the plumbing lines and
time to put the system in service and check your work
STOP - IF YOU DID NOT FOLLOW THe INSTRUCTIONS:
startup procedures have been followed.
minimum
1" air gap
outlet
open
open inlet & outlet
system is in service position
look for clear
water coming
from the drain
CAUTION:
If the drain water
remains grey,
repeat backwash
until water runs
clear
Illustration Purposes only:
bypass not pictured
inlet
open
View:
front/facing valve
15