Electrical Connection - Environmental Water Systems EWS-SPECTRUM-V2 Product And Installation Manual

installation Instructions - all systems - electrical connections
INSTALL eLeCTRICAL CONNeCTION
10. Plug system into a standard grounded, unswitched 110/115/120v electrical outlet.
If outlet is over 15 feet away use 18 gauge extension cord to connect up to 100 feet away.
Do not exceed 100 feet. Do not cut or splice original equipment.
NOTe: POWeR CONSUMPTION
CAUTION:
screen and what you see when the system is on
WHeN YOU PLUG THe SYSTeM IN:
Blue Backlight and Home Screen
Display reads: our company name and website
address across the top and the customer service
contact
BLUe:
Home screen and Clock settings, Time of day
and # of Days to Regen.
GReeN:
Backwash & Rinse cycles, Fitlering (returning to
service from Regen) and other programming
energy Savings Backlight Control:
The Blue Backlight is set to energy saving mode.
The light will turn off after 5 minutes of keypad
inactivity or 30 seconds after water usage. Touch
any button and the backlight will light up.
Features of this Valve:
Power backup continues to keep time and the passage of days for a minimum of 48 hours in the event of power failure.
A backwash can be triggered immediately by pressing the Regen button for five seconds.
When the system begins to backwash, the display will change to include information about the backwash process and the
time remaining for that step to be completed. The current cycle display of either backwash or rinse will alternate with the
total regen time remaining screen for the self-cleaning backwash. The system runs through the steps automatically and will
reset itself to provide treated water when the entire backwash process has been completed.
While the valve is transferring to a new cycle step, the display will flash. The parameter display will identify the destination
cycle step (Backwash or Rinse) and the display will read the cycle and the time in that cycle. Once the valve reaches the
cycle step, the display will stop flashing and the display will count down the time remaining in that cycle.
During backwash or rinse cycle, you can advance to the next cycle after the display stops flashing and begins the count-
down by pressing the Regen button until you see the display change.
To check the time of day, press the Next button, press again to see the # of Days to Regen and press again to return to
home screen
Maintain the ground to the plumbing system for the home.
If the home's plumbing system is copper (or any metal) then it may be necessary to install a jumper.
Install a jumper between the incoming and outgoing pipes before and after the flexible stainless
connections to maintain the continuity of the systems' ground. Properly ground system to conform
with all codes and ordinances.
ok, lets, set the clock
Power consumption is that of a radio alarm clock or a doorbell.
CloCK
reGeN
eWsWATer CoM
2568182
702
up button
down button
12
NeXT