Touchpad - HP ENVY x360 Maintenance And Service Manual

2. Release the ZIF connector (2) the touchpad cable is connected to, and then disconnect the
touchpad cable from the touchpad.
3. Detach the touchpad cable (3) from the computer. The touchpad cable is attached to the computer
with double-sided tape.
4. Remove the touchpad cable.
To replace the touchpad cable, reverse the removal procedures.

Touchpad

To remove the touchpad, use this procedure and illustration.
Table 5-11 Touchpad description and part number
Description
Touchpad:
NOTE: The touchpad spare part kit does not include the touchpad bracket or touchpad cable. The
touchpad bracket is not available as a spare part. The touchpad cable is available using spare part
part number N09466-001.
Before removing the touchpad, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the touchpad cable (see
Remove the touchpad:
1. Remove the three Phillips M2.0 × 2.2 screws (2) that secure the touchpad to the computer on the top
edge of the touchpad.
Preparation for disassembly on page
Bottom cover on page
Battery on page 31).
Touchpad cable on page
30).
50).
Spare part number
N41017-001
30).
Touchpad 51