HP ENVY x360 Maintenance And Service Manual page 41

devices in your country or region. If you replace the module and then receive a warning message,
remove the module to restore device functionality, and then contact technical support.
Before removing the WLAN module, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the WLAN module:
1. Remove the shield material (1) that covers the WLAN module.
2. Remove the WLAN module antenna cover (2) that secures the WLAN antenna cables to the WLAN
module.
The WLAN module antenna cover is available using spare part number N41046-001.
3. Carefully disconnect the two WLAN antenna cables (3) from the terminals on the WLAN module.
Computer models have either one or two WLAN antennas. On models with two antennas, the #1
WLAN antenna cable connects to the WLAN module #1 Main terminal. The #2 WLAN antenna cable
connects to the WLAN module #2 Aux terminal.
4. Remove the Phillips M2.0 × 3.2 screw (4) that secures the WLAN module to the system board.
The WLAN module tilts up.
5. Remove the WLAN module (5) by pulling the module away from the slot at an angle.
Preparation for disassembly on page
Bottom cover on page 30).
Battery on page 31).
30).
WLAN module 35