Segway SGW500F-A7 Owner's Manual page 90

OPERATION
• Never disconnect the power supply when there is a load on
the winch.
• After the operation, please release the load immediately, and
do not tighten the cable.
• Always stay away from ropes, hooks and winches.
• Check winches, ropes, hooks, and broken strands of worn
wires regularly. When handling the steel wire rope, please
wear thick leather gloves. Do not let the steel wire rope
slip over your hands. Check the steel rope before use. The
crushed, pinched, worn or kinked area has seriously reduced
the carrying capacity. The damaged steel wire rope should
be replaced. It must be re-wound under a load of about 100
pounds.
• The clutch should be disconnected first, and then the wire
rope should be pulled by the hook of the protective lever. Do
not pull the wire rope directly through the hook with your
fingers.
• Maintain the specified tension so that the cable can be
wound on the reel and re-rolled after the operation tight.
• Do not operate the winch under the influence of alcohol or
drugs. In operation, be vigilant during the process. If there is
a problem, you should cut off the battery immediately and
check it-carefully.
• Wear goggles, insulating overalls, non-slip shoes, work caps,
thick leather gloves. Place your hair tightly under the work
cap and remove all jewelry.
• Do not mechanically process or melt any part of the winch.
• When the winch is in use, be sure to start the vehicle engine
and set the gear position to "N" to make sure battery is
charging.
• When the winch is working, the current is large, so you must
start the vehicle and step on the accelerator lightly to avoid
80