COMMANDS
ASCII
ESC f
Hex
1Bh + 66h + n
Description
Status request
This command requests a stamper status report.
The response byte is sent via the serial port without any control
ASCII
ESC A
Hex
1Bh + 41h + n1 + n2
Description
Moves the step motor
This command moves the step motor in direction n1, n2 lines
ASCII
ESC z
Hex
1Bh + 7Ah + n
Description
Sets the number of lines for Form Feed
This command sets the maximum number of lines for the Form Feed.
bit 0 = PAPER
bit 1 = NOTCH
bit 2 = F-FEED
bit 3 = L-FEED
bit 4 = ERROR
bit 5 = CUTTER PRESENT
bit 6 =
bit 7 = MOTOR STATUS
n1 == 0
forward
n1 <> 0
backward
n2 =
number of steps
17
TP 2000
Need help?
Do you have a question about the TP 2000 and is the answer not in the manual?