Custom Engineering TP 2000 User Manual page 13

COMMANDS
ASCII CR
Hex 0Dh
Description Carriage Return
If AUTOFEED is ON, functions like the LF command; if OFF this command is ignored.
ASCII LF
Hex 0Ah
Description Line Feed
When this command is received, all data in the line buffer is printed out. If the buffer is
empty, the paper is fed one line.
ASCII ESC d
Hex 1Bh + 64h + n
Description Feed paper n lines
When this command is received, < n > line feeds are carried out.
N.B.: This command does not print out the line buffer.
ASCII ESC !
Hex 1Bh + 21h + n
Description Select print mode
This command selects the print mode. Depending on the status of the <n> bits, it activates
or deactivates the double height, double width or underline options, where n1 :
ASCII ESC R
Hex 1Bh + 52h + n
Description Selects font to be used
Selects one of the available fonts. This number is displayed during the start-up test.
If <n> is greater than this number it is ignored.
This command permits the use of all available fonts during a single work session, but
the printer will return to the default font following initialization.
Control commands list
bit 0 = 1 = double width
bit 1 = 1 = double height
bit 2
bit 3
bit 4
bit 5
bit 6
bit 7 = 1 = underline
13
TP 2000