Hoover H-OVEN 500 PLUS HOC5S747INWFS User Instructions page 29

Pyrolysis
The oven is equipped with a pyrolyser cleaning
system, which destroys food residues at high
temperature. The operation is carried out
automatically by means of the programmer.
The resulting fumes are rendered "clean" by
passing over a Pyrolyser wich starts as soon
as cooking begins. As very high temperatures
are required by the Pyrolyser, the oven door
is fitted with a safety lock. The pyrolyser can
be stopped at any time. The door cannot be
opened until the safety lock is displayed.
NOTE : If a hob has been fitted above the oven,
never use the gas burners or the electric hot-
plates while the Pyrolyser is working, this will
prevent the hob from overheating.
TWO PYROLYTIC CYCLE are pre-set:
PYROLYSIS ECO : Cleans a moderately stained
oven. Operates for a period of 90 minutes.
PYROLYSIS + : Cleans a heavily stained oven.
Operates for a period of 120 minutes.
Never use commercially available cleaning
products on a Pyrolytic oven!
Tip : Carrying
immediately after cooking allows you to take
advantage of residual heat, thus saving energy.
Before executing a pyrolytic cycle:
•Remove all the accessories from the oven
because they are not able to tolerate the
high temperatures used during the pyrolytic
cleaning cycle ; in particular removing grids,
side racks and the telescopic guides (refer
to the chapter REMOVING GRIDS AND SIDE
RACKS) .
•Remove any large spillages or stains as
it would take too long to destroy them.
Also excessively large amounts of grease
could ignite when subject to the very high
temperatures of the Pyrolytic cycle.
•Close the oven door.
•Excess spillage must be removed before
cleaning.
• Clean the oven door;
• Remove large or coarse food residues from
the inside of the oven using a damp sponge.
Do not use detergents;
out Pyrolytic cleaning
• Remove all accessories and the sliding rack
kit (where present);
• Do not place tea towels.
Using the pyrolitic cycle:
1- Tap icon to select the cleaning functions
(d) and, using the navigation buttons, choose
the preferred pyrolitic cycle.
2- It is possible to defer the start time of the
pyroclean cycle by changing the END time via
the programmer.
3- After few minutes, when the oven reaches a
high temperature, the door locks automatically.
The pyroclean cycle can be stopped at any
time by pushing On/Off button.
4- Once the pyroclean cycle is finished, the
pyrolysis will switch off automatically.
EN 29