Getting Started - Hanseatic HWM7T3l16C User Manual

Getting started

Before getting started
• First read chapter "Intended use" and
chapter "Safety notices" (see page EN-4
and the following).
• Remove the transport safety devices and
prepare the appliance as described in
chapter "Installation, connection and initial
commissioning" (see page EN-31).
• Properly attach the water inlet hose (34)
and the water outlet hose (18).
Possible residual water or drops in the
appliance are merely a sign that it was
tested for functionality during production.
The appliance requires an initial wash cycle
without laundry, but with detergent (test run).
The aim of this is to rinse out possible resi-
dues from production.
1. Check whether the water inlet hose and
water outlet hose (18) are securely con-
nected.
2. Open the valve completely.
3. Make sure that the drum is empty.
4. Push the loading door (15) tightly closed.
(21)
(1)
5. If the partition (21) is located in the left
chamber II of the dispensing drawer (1),
take it out. Keep it safe as it is needed
when liquid detergent is used.
6. Dispense a maximum of 25 ml of compact
detergent into left chamber II.
Installation, connection and initial commissioning
7. Set the cycle selector (2) to the "Cotton"
8. Press the
9. Turn the cycle selector (2) to "Off". Take
Start-up is now finished.
(2) (4)
cycle.
The cycle time is shown in the display (4).
button (7).
The cycle starts and the remaining cycle
time is shown in the (4) display.
After the cycle is finished, "End" is shown
in the display (4).
the mains plug out of the socket and turn
off the tap.
Page EN-35
(7)
Schnell