Hanseatic HWM7T3l16C User Manual page 80

Page EN-38 Troubleshooting table
Problem
During the wash
cycle, no water
can be seen in the This is not an error. The water is at the bottom of the drum.
drum through the
glass panel.
Loading door won't
This is not an error. The opening mechanism contains a safety device
open after the
that keeps the loading door closed another 2 minutes or so after the
wash cycle has fin-
wash cycle has finished.
ished.
Error code E01 Loading door is not closed.
Error code E02 Water level in the appliance is
lower than the heating coil.
Error code E03 Pump is faulty or lint trap is
clogged.
Error code E04 Too much water in the appli-
ance.
Error code E09 Problem with power supply
Malfunction
Possible causes Solutions, tips
Close loading door properly.
If the problem persists, please con-
tact our Service department (see
page EN-39).
The water pressure, to which the appli-
ance is connected may be too low or
the valve may be closed.
If necessary, open the valve com-
pletely. If the problem persists, please
contact our Service department (see
page EN-39).
Clean lint trap (see page EN-29). If the
problem persists, please contact our
Service department (see page EN-39).
The appliance is automatically pumping
water away. After draining, switch off
the appliance, pull the mains plug out of
the socket and close the valve. Please
contact our Service department (see
page EN-39).
Please contact our Service department
(see page EN-39).