Table of Contents
Advertisement
Problem
"Fill water tank" appears even though the
water tank is not yet empty, or the water
tank is empty but "Fill water tank" does not
appear
The water tank empties for no discernible
reason. The evaporator dish overflows
The evaporator dish has boiled empty
even though the water tank is full.
"Empty/Clean tank?" appears in the dis-
play
There is a "pop" noise during cooking
When you cook with steam, a lot of steam
is created
When cooking with steam, a great deal of
steam is created again
Steam escapes from the ventilation slots
during cooking
The appliance is not producing steam
properly
Error message "E011" appears in the tem-
perature display
An error message "E..." appears in the
temperature display
The appliance is no longer heating. The
colon is flashing in the clock display. For
example,
appears in the tempera-
‚‹‹©
ture display
Replacing the cooking compartment bulb
Heat-resistant 230 V/25 W halogen bulbs with seals are
available from the after-sales service. Please specify the E
number and FD number of your appliance.
:
Risk of burns!
Allow the cooking compartment and cooking compartment light
to cool before changing the bulb.
Always use a dry cloth to remove a new halogen bulb from the
packaging, otherwise it will not last as long.
Switch off the fuse in the fuse box or unplug at the mains.
1.
Turn the cover anti-clockwise to remove.
2.
Remove the bulb and replace with a bulb of the same type.
3.
Slide the new seals and the clamping ring onto the glass
4.
cover in the right order.
26
Possible cause
The water tank is dirty. The moving water
level indicators are jammed
The water tank was not closed properly
The tank lid seal is dirty
The tank lid seal is faulty
The water tank has not been inserted
properly
The feed line is blocked
The appliance has not been used for at
least two days and the water tank is full
Cold/warm effect with frozen food, caused
by the steam
The appliance is being automatically cali-
brated
The appliance is unable to calibrate itself
automatically if cooking times are too
short
Limescale has formed in the appliance
A button was pressed for too long or is
jammed
Technical fault
A button combination was actuated
Screw the glass cover with the seals back on again.
5.
Connect the appliance to the mains and reset the clock.
6.
Never operate the appliance without the glass cover and seals.
Replacing the glass cover or seals
Any damaged glass cover or seals must be replaced. Please
provide the after-sales service with the E number and FD
number of your appliance.
Notes/remedy
Shake and clean the water tank. If the
parts cannot be freed, obtain a new water
tank from the after-sales service
Close the lid until you feel it lock into place
Clean the seal
Obtain a new water tank from the after-
sales service
Push in the water tank until it locks into
place
Descale the appliance. Check whether the
water hardness range is set correctly
Empty and clean the water tank. Always
empty the water tank after cooking
This is normal
This is normal
Restore the appliance to the factory set-
ting (see section: Basic settings). Then
start
Steam cooking at 100 °C for
é
20 minutes
This is normal
Descale the appliance (see section: Des-
caling).
Press the
KJ
clock function button to
delete the error message. Press all of the
buttons individually and check if they are
clean
Press the
clock function button to
KJ
delete the error message, and reset the
clock if necessary. If the error message
appears again, call the after-sales service
Switch off the appliance, press and hold
the
info button for 3 seconds, then press
±
and hold the
clock function button for
KJ
4 seconds, then press and hold the
button for 3 seconds
±
info
Advertisement
Table of Contents
