Table of Contents
Advertisement
Attaching the rail
Position the rail so that the indentations are facing upwards.
1.
Hook the rail in at the back and push it towards the rear until
2.
it engages (fig. C).
Hook the front of the rail onto the holder and press down until
3.
it engages and is fixed level in place in the appliance once
more (fig. D).
Troubleshooting
Malfunctions often have simple explanations. Please read the
following instructions before calling the after-sales service.
Repairs may only be carried out by fully trained after-sales
service technicians. Incorrect repairs to your appliance may
present considerable risks for the user.
Problem
The appliance does not work
The appliance cannot be started
The appliance cannot be started. "Des-
cale" appears in the text display.
The appliance cannot be started. "Clean"
appears in the text display.
:
flashes in the clock display
‹
‹‹
‹
:
‹‹
flashes in the clock display,
appears in the temperature display
The appliance is not in operation. A cook-
ing time is shown on the display.
"Safety cut-out" appears in the text display
and
flashes in the temperature dis-
‹‹‹
play
‹‹‹
flashes in the temperature display
"Fill water tank" appears even though the
water tank is full
Possible cause
The plug is not plugged in
Power cut
Circuit-breaker faulty
Faulty operation
The appliance door is not fully closed
The appliance is not switched off
Descaling has been cancelled
Cleaning aid was cancelled
Power cut
Power cut during cooking
§§§
The Start button was not pressed after the
setting had been made.
Automatic safety cut-out is active
The appliance is not switched off
The water tank has not been inserted
properly
The detection system is not working
Each set of rails only fits on one side.
:
Risk of electric shock!
Work on the appliance electronics may only be performed by
■
a specialist.
Always disconnect the appliance from the power supply
■
when work is carried out on the electronics. Switch off the
circuit breaker or remove the fuse from your household fuse
box.
Notes/remedy
Connect the appliance to the electricity
supply
Check whether other kitchen appliances
are working
Check in the fuse box to make sure that
the circuit-breaker for the appliance is OK
Switch off the circuit-breaker for the appli-
ance in the fuse box and switch it back on
after approx. 10 seconds
Close the appliance door
Turn the operating mode selector back to
the
Û
Press the Start button. Then rinse the
appliance twice (see section: Descaling).
Proceed as described in the section "Emp-
tying the evaporator dish and refilling the
water tank".
Press the Start button. Then rinse the
appliance twice (see section: EasyClean®
cleaning aid. Proceed as described in the
section "Emptying the evaporator dish and
wiping out the appliance")
Reset the clock (see section: Electronic
clock)
Press the
the clock (see section: Electronic clock)
Press the Start button or delete the setting
with the Stop button
Turn the operating mode selector back to
the
Û
Turn the operating mode selector back to
the
Û
Push in the water tank until it locks into
place.
Call the after-sales service
position and switch on again.
KJ
clock function button, reset
position and lock it in place
position and lock it in place
25
Advertisement
Table of Contents
