Pair The Tonometer With Your Mobile Device; Transfer Measurement Data Via Bluetooth - Icare PATIENT2 Instruction Manual

2. Press until you see SETTINGS on the tonometer screen, and press
3. Press until you see BLUETOOTH, and press
4. If Bluetooth is off, press

7.2. Pair the tonometer with your mobile device

1. Tap Bluetooth. Allow the prompted requests to continue pairing.
2. Select the correct tonometer from the list of detected iCare HOME2
tonometers. Make sure that the serial number of the tonometer on the
mobile device's screen matches thet of the one found at the back of
the tonometer. The serial number found on your tonometer is marked
with SN.
3. Tap PAIR TONOMETER.
4. At the Bluetooth pairing request, enter the PIN code shown on the
tonometer's screen, and tap OK.
5. When the tonometer has been successfully paired, tap CONTINUE on
the PATIENT2 screen.
You can now tap SYNC to transfer measurement results from the
tonometer to iCare CLINIC or iCare CLOUD, or log into the iCare PATIENT2
app, to see your previous measurement results.
8. Transfer measurement data via
Bluetooth®
Tip: If you have previously paired your tonometer via USB cable, you will
need to pair it again. Go to the settings and tap Change the tonometer
and re-pair to use Bluetooth pairing.
1. Switch on the tonometer.
2. On your mobile device, open the iCare PATIENT2 app.
until you see TURN ON, and press
8
.
.
.