Winding And Inserting The Bobbin - VERITAS Power Stitch 17 Manual

Winding and inserting the bobbin

1
5
9
5) Step on the foot control to start winding the bobbin.
6) After the bobbin has wound a few rounds, stop the machine and cut the thread near the hole of the
bobbin. Continue filling the bobbin until it is full. Stop the machine, then push the bobbin winder spindle to
the left.
7) Cut the thread and then remove the bobbin. When the bobbin winder spindle is pushed to the right
position, the machine is not allowed to sew and the handwheel will be locked.
8) The needle must be fully raised. Remove the sewing table, then open the hinged cover. Pull the bobbin
case by the hinged latch. Remove the bobbin of the bobbin case.
9) Insert the bobbin so that the thread runs in a clockwise direction. Pull the thread from the slot under the
tension spring and through the opening. Leave a 15 cm tail of thread. Hold the bobbin case by the hinged
latch. Make sure the bobbin case finger fits into the notch at the top of the race as shown in. Close the
hinged cover.
2
6
1) Place the thread and spool holder onto the
spool pin. For better sewing quality, choose a
proper size of the spool holder for the thread and
attach it next to the spool.
2) Draw the thread from the spool and place the thread in between the
thread guide. Wind the thread clockwise around the tension discs.
3) Place the thread end through one of the inner holes and place the empty
bobbin on the bobbin winder spindle. Then align the notch with bobbin
winder spindle spring.
4) Push the bobbin to the right. Hold the thread tail securely in one hand.
3
7
10
4
8