Inserting The Bobbin - VERITAS Anna Instruction Manual

Inserting the bobbin

2
3
1
1
3
2
1
Attention:
Turn the power switch to off ("O")
before inserting or removing the
bobbin.
When inserting or removing the
bobbin, the needle must be fully
raised.
Remove the sewing table, then open
the hinged cover.
Pull the bobbin case by the hinged
latch.Remove the bobbin of the bobbin
case.
Hinged latch
1
Hold the bobbin case with one hand.
Insert the bobbin so that the thread
runs in a clockwise direction (arrow).
Pull the thread from the slot under
the tension spring and through the
opening. Leave a 15cm tail of thread.
Slot
1
Tension spring
2
Opening
3
Hold the bobbin case by the hinged
latch. Make sure the bobbin case
finger fits into the notch at the top of
the race as shown in. Close the hinged
cover.
Hinged latch
1
Bobbin case finger
2
Notch
3
Note:
If the bobbin case is not properly
placed back into the machine, it will
fall out form the shuttle immediately
after starting to sew.
14