Extron electronics Decorator-Style Series Setup Manual page 8

Network Button Panel — Decorator-Style Series • Setup Guide (Continued)
Mounting
NOTES:
•
Extron recommends taking safety
precautions to avoid electrostatic
discharge issues during installation
•
For best results, Extron recommends
grounding the NBP if the junction box
or mud rings are not already grounded
(see the instructions in the user guide).
Mount the NBP as follows:
Insert the cabled NBP into the mud ring
1.
or junction box within the wall or furniture,
aligning the mounting holes
in the NBP mounting tabs with those in box
or mud ring.
Secure the NBP to the junction box, wall
2.
or surface mounting box, or mud ring as
follows (see the figures at right):
Insert the included screws through the
a.
mounting holes at the top and bottom
of the unit and into the corresponding
threaded holes in the box or mud ring.
Using a Phillips screwdriver, lightly
b.
tighten the screws until snug.
ATTENTION:
•
Do not overtighten the screws.
•
Veillez à ne pas trop serrer les
vis.
Attach the wallplate to the NBP: insert the
3.
included screws through the circular holes in
the wallplate and the tabs on the NBP (see
figures at right). Tighten the screws using a
flat bladed screwdriver until snug.
8
Mud Ring
NBP 105 D
Figure 12. Installing the NBP in a Mud Ring
Electrical
Junction
Box
Figure 13. Installing the NBP in a Junction Box
Wall
P C
O P
P T
L A
E O
V I D
E R
A Y
P L
D IA
M E
M I
H D
Wallplate
Wall
P C
O P
P T
L A
E O
V I D
R
Y E
L A
A P
D I
M E
M I
H D
NBP 105 D
Wallplate