3 WORK
3.9
3.10
24
Installing the front wheel
Warning
Danger of accidents Oil or grease on the brake discs reduces the braking effect.
–
Always keep the brake discs free of oil and grease.
–
Clean the brake discs with brake cleaner when necessary.
H00935-10
V00364-11
Installing front fender
V00340-10
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Change front wheel bearing.
–
Clean and grease shaft seal rings
of the spacers.
Long-life grease (
p. 43)
–
Insert the spacers.
–
Clean and grease the wheel spindle.
Long-life grease (
p. 43)
–
Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
Guideline
Screw, front wheel
spindle
–
Operate the hand brake lever several times until the brake lin-
ings are seated correctly against the brake disc.
–
Remove the motorcycle from the lift stand. (
–
Operate the front brake and compress the fork a few times
firmly.
The fork legs straighten.
–
3
Tighten screws
.
Guideline
Screw, fork stub
Main work
(EXC‑F EU/AU/US)
–
Position front fender. Mount and tighten screws
Guideline
Remaining screws,
chassis
1
and contact surface
2
.
M20x1.5
35 Nm (25.8 lbf ft)
p. 19)
M8
15 Nm (11.1 lbf ft)
1
M6
10 Nm (7.4 lbf ft)
A
.