Tighten Screws 3 . Guideline - KTM 450 EXC-F 2018 Setup Instructions

3 WORK
3.9
24
K00546-10
Installing the front wheel
Warning
Danger of accidents Oil or grease on the brake discs reduces the braking effect.
–
Always keep the brake discs free of oil and grease.
–
Clean the brake discs with brake cleaner when necessary.
H00935-10
V00364-11
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front M8
brake caliper
–
Mount the cable tie(s).
–
Position the brake line, wiring harness, and clamp. Mount and
5
tighten screws .
Finishing work
–
Install the front wheel. (
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change front wheel bearing.
–
Clean and grease shaft seal rings
of the spacers.
Long-life grease ( p. 42)
–
Insert the spacers.
–
Clean and grease the wheel spindle.
Long-life grease ( p. 42)
–
Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
Guideline
Screw, front wheel
spindle
–
Operate the hand brake lever several times until the brake lin-
ings are seated correctly against the brake disc.
–
Remove the motorcycle from the lift stand. (
–
Operate the front brake and compress the fork a few times
firmly.
The fork legs straighten.
–
3
Tighten screws .
Guideline
Screw, fork stub
25 Nm (18.4 lbf ft)
Loctite
p. 24)
p. 20)
p. 21)
1
and contact surface
2
.
M20x1.5 35 Nm (25.8 lbf ft)
p. 19)
M8 15 Nm (11.1 lbf ft)
4
.
® 243™
A