3.5
Checking the headlight setting
3.6
Adjusting the headlight range
–
Position the headlight mask and secure it with rubber
2
straps
The holding lugs engage in the fender.
–
Position the brake line and wiring harness in the brake line
guide.
V00469-11
Finishing work
–
Check the headlight setting. (
–
Position the vehicle upright on a horizontal surface in front of
a light wall and make a marking at the height of the center of
the low beam headlight.
–
Make another mark at a distance
Guideline
B
Distance
–
Position the vehicle vertically at a distance
wall.
400726-10
Guideline
A
Distance
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the
lower mark for a motorcycle with rider.
»
If the boundary between light and dark does not meet
specifications:
–
Adjust the headlight range. (
Preparatory work
–
Check the headlight setting. (
Main work
–
Loosen screw
–
Adjust the headlight range by pivoting the headlight.
Guideline
The boundary between light and dark must be exactly on the
lower mark for a motorcycle with rider (instructions on how
to apply the mark: Checking the headlight setting).
V00369-10
.
p. 21)
B
under the first marking.
5 cm (2 in)
5 m (16 ft)
p. 21)
p. 21)
1
.
WORK 3
A
away from the
21