Mount And Tighten Screws - KTM 450 EXC-F Six Days 2019 Setup Instructions

Warning
Danger of poisoning Fuel is poisonous and a health hazard.
–
Avoid skin, eye and clothing contact with fuel.
–
Immediately consult a doctor if you swallow fuel.
–
Do not inhale fuel vapors.
–
In case of skin contact, rinse the affected area with plenty of water.
–
Rinse the eyes thoroughly with water, and consult a doctor in case of fuel contact with the eyes.
–
Change your clothing in case of fuel spills on them.
K00556-10
K00558-11
H01699-10
Main work
–
Check throttle cable routing. (
–
Position the fuel tank and fit the two spoilers to the sides in
front of the radiator bracket.
–
Make sure that no cables or throttle cables are trapped or dam-
aged.
–
Attach the fuel tank breather hose.
–
Mount and tighten screw
Guideline
Remaining screws,
chassis
–
Position the horn with the horn bracket.
–

Mount and tighten screws

Guideline
Remaining screws,
chassis
(EXC‑F EU/AU, EXC‑F Six Days EU)
–
3
Plug in connector
–
Remove the wash cap set.
–
Thoroughly clean the plug-in connection of the fuel line
using compressed air.
Info
Under no circumstances should dirt enter into the
fuel line. Dirt in the fuel line clogs the injection
valve!
–
Lubricate the O-ring and connect plug-in connection
for the fuel line.
Info
Route the cable and fuel line at a safe distance
from the exhaust system.
p. 34)
1
with the rubber bushing.
M6 10 Nm (7.4 lbf ft)
2
with the collar bushings.
M6 10 Nm (7.4 lbf ft)
for the fuel pump.
WORK 3
4
33