KTM 450 EXC-F Six Days 2019 Setup Instructions page 8

2 SETUP
6
(All EXC‑F Six Days)
–
Remove screws
–
Move the handlebar supports to the desired position and
mount and tighten screws
Guideline
Screw, handle-
bar holder
Info
Position the left and right handlebar supports
evenly.
S01415-10
Warning
Danger of accidents A repaired handlebar poses a
safety risk.
If the handlebar is bent or straightened, the mate-
rial becomes fatigued. The handlebar may break
as a result.
–
S01413-01
–
Position handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position handlebar clamps. Mount and tighten the screws
evenly.
Guideline
Screw, handlebar
clamp
Info
The markings on the handlebar should be at the
center of the handlebar clamps.
Keep the installed gap widths equal when tighten-
ing.
3
and take off handlebar supports.
3
.
M10 40 Nm (29.5 lbf ft)
Change the handlebar if the handlebar is dam-
aged or bent.
M8
Loctite ® 243™
20 Nm
(14.8 lbf ft)