Tighten Screws 3 . Guideline - KTM 150 EXC TPI 2021 Setup Instructions

3 WORK
3.11
24
H00935-10
V00364-11
Removing the 12-V battery
Note
Environmental hazard 12 V batteries contain environmentally hazardous materials.
–
Do not dispose of 12 V batteries as household waste.
–
Dispose of 12 V batteries at a collection point for used batteries.
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with
the applicable regulations.
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change front wheel bearing.
–
Clean and grease shaft seal rings
of the spacers.
Long-life grease ( p. 43)
–
Insert the spacers.
–
Clean and lightly grease the wheel spindle.
Long-life grease ( p. 43)
–
Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
Guideline
Screw, front wheel
spindle
–
Operate the hand brake lever several times until the brake lin-
ings are seated correctly against the brake disc.
–
Remove the motorcycle from the lift stand. (
–
Operate the front brake and compress the fork a few times
firmly.
The fork legs straighten.
–
3
Tighten screws .
Guideline
Screw, fork stub
Preparatory work
–
Remove the seat. ( p. 17)
1
and contact surfaces
2
.
M20x1.5 35 Nm (25.8 lbf ft)
p. 17)
M8 15 Nm (11.1 lbf ft)
A