KTM 450 EXC-F Six Days 2019 Setup Instructions page 25

–
Tighten screws
Guideline
Screw, top triple
clamp
–
Tighten screws
Guideline
Screw, bottom
triple clamp
V00452-11
(All EXC‑F Six Days)
–
Position the fork legs.
Bleeder screws
Info
The rebound damping is located in right fork
leg REB (red adjusting screw). The compression
damping is located in left fork leg COM (white
adjusting screw).
402556-10
Grooves are milled into the side of the upper end of
the fork legs. The second milled groove (from the
top) must be flush with the upper edge of the upper
triple clamp.
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Tighten screws
Guideline
Screw, bottom
triple clamp
V00453-11
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front
brake caliper
–
Mount the cable tie.
–
Position the brake line, wiring harness, and clamp. Mount and
tighten screws
K00546-10
Finishing work
–
Install the front wheel. (
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
2
.
M8 20 Nm
(14.8 lbf ft)
3
.
M8 15 Nm
(11.1 lbf ft)
1
are positioned toward the front.
2
.
M8 17 Nm
(12.5 lbf ft)
3
.
M8 15 Nm
(11.1 lbf ft)
M8 25 Nm (18.4 lbf ft)
5
.
p. 24)
p. 21)
WORK 3
4
.
Loctite ® 243™
p. 20)
23