Tighten Screws 3 . Guideline; Mount And Tighten Screw - KTM 250 SX Setup Instructions

3.5 Installing front fender
3.6 Installing the start number plate
–
Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–

Mount and tighten screw

Guideline
Screw, front wheel
spindle
–
Operate the hand brake lever several times until the brake lin-
ings are seated correctly against the brake disc.
K00454-11
–
Remove the motorcycle from the lift stand. (
–
Operate the front brake and compress the fork a few times
firmly.
The fork legs straighten.
–
Tighten screws
Guideline
Screw, fork stub
Main work
–
Position front fender. Mount and tighten screws
Guideline
Remaining screws,
chassis
M01144-10
Finishing work
–
Install the start number plate. (
–
Connect the brake line at the start number plate.
–
Position the start number plate.
The holding lugs engage in the fender.
–
Mount and tighten screw
F00013-10
2
.
M20x1.5 35 Nm (25.8 lbf ft)
3
.
M8 15 Nm (11.1 lbf ft)
M6 10 Nm (7.4 lbf ft)
p. 11)
1
.
WORK 3
p. 9)
1 2
and .
11