Table of Contents
Advertisement
VIEW CHANNEL OF MULTIPLE WIRELESS SENSORS
This main unit can support up to 8 additional wireless sensor(s).
If you buy the additional wireless sensor(s) and paired with the main unit. Then, you can
press [ CH / + ] key to switch the display between CH 1~8.
In normal mode, press and hold [ CH / + ] key for 2 seconds to enter auto-cycle mode,
after a bi sounds, it will alternately displays the channels at 4 second intervals.
3.
During auto-cycle mode, press [ CH / + ] key once to stop auto-cycle and display the
current channel.
4.
Using auto-cycle mode will only display the communicated channels. For example,
when CH 1 and 6 have received the signal from the corresponding sensor, press and
hold [ CH / + ] key for 2 seconds will only toggle the readings of CH 1 and 6. Other
channels will be neglected.
CH 1
RECEPTION OF RADIO CONTROLLED SIGNAL
The time and date are radio-controlled. The current time and date are automatically
synchronized with the signal that transmitted from RC station through wireless sensor.
Please make sure the bundle wireless sensor is connected to the main unit.
RCC SIGNAL STRENGTH INDICATOR
The signal indicator shows signal receive status. Flashing wave segment means RCC
signals are being received. The signal receiving status could be classified into 2 types:
No RCC signal received
NOTE:
- Every day the wireless sensor will automatically search for the time signal at 2:00 and
17:00.
- Always place the unit away from interfering sources such as TV set, computer, etc.
- Avoid placing the unit on or next to metal plate.
- Closed area such as airport basement, tower block or factory is not recommended.
- Do not start reception on a moving article such as vehicle or train.
CH 6
Received RCC signal
8
CH 1
Advertisement
Table of Contents
