Table of Contents
Advertisement
OPTIONAL ACCESSORIES
General Information
The following pages provide information on
Goldacres optional accessories available on this
1
equipment.
PART NUMBER
GA5013603
HOS25PVC
Chemical Induction Probe
HB100-90
Overview
100E
GA5018319
A simple method of transferring chemical into the
GA5001681
sprayer tank is via the chemical probe. The chemical
probe enables the chemicals to be transferred with
minimal exposure to the operator. The probe is used
in conjunction with the Venturi filler (located on the
top of the tank) which creates the required suction
on the pressure side of the pump.
The viscosity of the chemical being transferred will
affect the rate of suction flow and hence the amount
of time required to transfer the chemical. Water
and air have low viscosities whereas molasses is an
example of a highly viscous liquid. The higher the
viscosity of the liquid, the longer it takes to transfer
Prairie 1500-3000L Operator's Manual MY17-MY19 - REV 0
2
DESCRIPTION
PVC pipe 25mm cut 630mm
PVC hose 25mm cut 3.2m
Hose barb 90 degree 1" Banjo
Male Adapter 1" Hose Shank
Ball valve 25mm FF Lever
1" SS hose clamp
Chapter 12
NOTE: These options may not be fitted to your
sprayer unless ordered.
3
QTY.
1
1
1
1
1
via the chemical probe. If the viscosity of a chemical
2
is such that it takes too long to transfer, dilute the
chemical with water, which will reduce the viscosity,
and then transfer the solution.
The chemical should be transferred after about 20-
50 % of the required water quantity has been added
to the sprayer tank. This will ensure that agitation
takes place when the remaining water is added.
The end of the probe is not flat so that the probe,
when placed flat against the bottom of the container,
will not restrict the flow of chemical.
Chapter 12 - Optional Accessories - 77
4
Continued over page
5
Advertisement
Table of Contents
