Table of Contents
Advertisement
Console Mounting
The mounting of the consoles within the cabin of
your tractor is a critical part of the set up process. It
is important that the consoles are mounted in the
cabin in such a way that it cannot cause harm to the
operator under any circumstance while also being
mounted in a user friendly way.
When the sprayer is removed from the tractor, and
the consoles are to remain fitted, please ensure
that all consoles remain firmly mounted and cannot
become a projectile.
For specific information on mounting the consoles,
please refer to the Raven installation and service
manual supplied.
If there are mounting holes in the pillars of the
tractor, a bracket (GA4522930) is supplied with the
console mounting kit to allow the console to be
mounted to the pillar.
Console Connection - Raven SCS450
The consoles should be connected according to
the electrical schematics following in this chapter.
These schematics provide you with a layout of all
connections to ensure that the system is properly
connected prior to operation.
CONSOLE POWER WIRING
With the consoles mounted in the cabin, turn the
power switch to OFF and route the positive red (+)
and negative black (-) battery wires to a 12V battery.
Attach the white battery wire to a negative terminal
and the red battery wire to a positive terminal.
NOTE: The negative should be connected last to
prevent the chance of a short.
26 - Chapter 7 - Pre-Operation
Above: Some tractors may have pre-drilled
mounting holes on the pillar which can be used with
the cabin mount bracket (GA4522930) to mount
the rate control console.
Prairie 1500-3000L Operator's Manual MY17-MY19 - REV 0
Ram mount
Cabin mount
bracket
Advertisement
Table of Contents
