Switch Box Mounting; Switch Box Connection - Goldacres Prairie Compact 2000L MY19 Operator's Manual

Switch Box Mounting

The mounting of the switch box within the cabin of
your tractor is a critical part of the set up process. It
is important that the switch box is mounted in the
cabin in such a way that it cannot cause harm to the
operator under any circumstance while also being
mounted in a user friendly way.
When the sprayer is removed from the tractor, and
the switch box is to remain fitted, please ensure that
it remains firmly mounted and cannot become a
projectile.
If there are mounting holes in the pillars of the
tractor, a bracket may be ordered separately
(GA4522930) to allow the console to be mounted
to the pillar.

Switch Box Connection

The switch box should be connected according to
the electrical schematic following in this chapter.
Ensure that the system is properly connected prior
to operation.
SWITCH BOX POWER WIRING
With the switch box mounted in the cabin, turn the
power switch to OFF and route the positive red (+)
and negative black (-) battery wires to a 12V battery.
NOTE: The negative should be connected last to
prevent the chance of a short.
20 - Chapter 7 - Pre-Operation
Above: Some tractors may have pre-drilled
mounting holes on the pillar which can be used with
the cabin mount bracket (GA4522930) to mount
the switch boxes or control consoles.
Prairie Compact 2000L Operator's Manual MY19 - REV 1
Ram mount
Cabin mount
bracket