Master/Slave Mode - Equinox Systems Fusion Saber User Manual

Master/slave mode:

To set the master unit, press the "MENU" button on the front of the master unit to show
LED display. Now press the "ENTER" button and use the "UP" and "DOWN" buttons to choose
Press the "ENTER" button to confirm the setting. Then select your desired program (sound active, DMX
or auto).
To set the other units in slave mode, press the "MENU" button on the front of the unit to show
on the LED display. Now press the "ENTER" button and use the "UP" and "DOWN" buttons to choose
SLAv
either . Press the "ENTER" button to confirm the setting. The unit will now run in sequence with
the master unit.
To exit out of any of the above options, press the "MENU" button.
Please ensure that all slave units are set to the same DMX channel mode as the master unit.
Show mode:
To access the show modes, press the "MENU" button on the front of the unit to show
on the LED display. Now press the "ENTER" button and use the "UP" and "DOWN" buttons to choose
Soud
between (Sound active) or
To exit out of any of the above options, press the "MENU" button.
Sound/sound sensitivity:
To turn the sound mode on or off, press the "MENU" button on the front of the unit to show
on the LED display. Now press the "ENTER" button and use the "UP" and "DOWN" buttons to choose
-on- -oFF
between or
To adjust the sound sensitivity, press the "MENU" button on the front of the unit to show
LED display. Now press the "ENTER" button and use the "UP" and "DOWN" buttons to choose between
0 100
~ . Value: 0 - 100 (0 = low, 100 = high)
To exit out of any of the above options, press the "MENU" button.
Manual mode:
To access manual mode, press the "MENU" button on the front of the unit to show
display. Now press the "ENTER" button and use the "UP" and "DOWN" buttons to choose between
Pan tILt
(Pan), (Tilt),
UhIt
(White 0-100%),
button to confirm the setting and use the "UP" and "DOWN" buttons to choose between
To exit out of any of the above options, press the "MENU" button.
Pan/Tilt offset:
To access the pan/tilt sub menu, press the "MENU" button on the front of the unit and then press and
hold the "ENTER" button show
Pan
between (Pan) and
buttons to adjust the value between
To exit out of any of the above options, press the "MENU" button.
www.prolight.co.uk
Auto
(Auto). Press the "ENTER" button to confirm the setting.
. Press the "ENTER" button to confirm the setting.
rEd
(Red 0-100%),
dINN
(Master dimmer 0-100%), or
Pan
on the LED display. Use the "UP" and "DOWN" buttons to choose
tILt
(Tilt). Now press the "ENTER" button and use the "UP" and "DOWN"
-127 127
~
GrEE
(Green 0-100%),
Stro
(Strobe). Press the "ENTER"
. Press the "ENTER" button to confirm the setting.
Fusion Saber User Manual
SLNd
Nast
SLNd
ShNd
Soud
SEns
Nanu
on the LED
bLuE
(Blue 0-100%),
0 255
~
on the
.
on the
.
7