Equinox Megabar Safety WARNING FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLY BEFORE YOUR INITIAL START-UP! CAUTION! Keep this equipment away from rain, moisture and liquids. SAFETY INSTRUCTIONS Every person involved with the installation, operation & maintenance of this equipment should: Be competent Follow the instructions of this manual...
Equinox Megabar Safety IMPORTANT: The manufacturer will not accept liability for any resulting damages caused by the non-observance of this manual or any unauthorised modification to the equipment. • Never let the power-cable come into contact with other cables. Handle the power-cable and all mains voltage connections with particular caution! •...
Page 4
Equinox Megabar Technical specifications You should find inside the carton the following items: 1, Equinox Megabar 2, Power cable 3, User manual Technical Specifications: DMX channels: 6, 9 and 15 selectable Operating modes: 1, Sound Activated 2, Built-in programmes 3, Auto Run 4, DMX 5, Slave 28 x 3W Tri-colour LEDs (total) - 7 x RGB tri-colour - per panel...
Page 5
Equinox Megabar Operation modes Operation modes: The Equinox Megabar has five modes of operation as follows: 1, Sound active mode To select the sound active mode, press the “MODE” button to show “SOUND MODE” in the LCD display window. Now press the “SETUP” button and use the “UP” and “DOWN” buttons to adjust the sound sensitivity level (SENS00-31) and press the “SET UP”...
Page 7
Equinox Megabar DMX Charts 6 channel DMX chart (All four LED pods adjusted at the same time) 9 channel mode (Adjusts the LED pods in pairs) CH 4 CH 5 CH 6 CH 7 CH 8 CH 9 Green Blue Green Blue pods...
Page 8
Equinox Megabar DMX set up DMX Control Mode Operating in a DMX control mode environment gives the user the greatest flexibility when it comes to customising or creating a show. In this mode you will be able to control each individual trait of the fixture and each fixture independently.
Page 9
Equinox Megabar DMX Set Up Notice: • Be sure to follow figures 2 & 3 when making your own cables. Do not connect the cable’s shield conductor to the ground lug or allow the shield conductor to come in contact with the XLR’s outer casing.
Page 10
Equinox Megabar Footswitch Operation Overview (top) Overview (back) Operations This foot controller is made specially for the Megabar system. All of the built-in programmes can be accessed via the 4 foot switches. To control the Megabar using the foot switch controller, you must first set the bar systems into “SLAVE”...