Table of Contents
Advertisement
Fitting
When fitting, make sure that the lettering "right above" is at the
top right on both panels.
Insert the lower panel diagonally downwards (fig. A).
1.
Insert the centre panel.
2.
Stick the retaining clips onto the right and left-hand side of
3.
the panel, aligning them so that the carriers are over the
screw holes, and then screw them in place (fig. B).
$
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Malfunction table
If a dish does not turn out exactly as you wanted, refer to the
Tested for you in our cooking studio section, where you will
find plenty of cooking tips and tricks.
Problem
The appliance does not work.
‹
‹‹
:
appears in the display.
The oven does not heat up or the type of
heating selected cannot be set.
The oven does not heat up. A small
square lights up in the temperature dis-
play.
s
When you press the
appears in the display.
"‰
"
" appears on the display.
"
Error messages with
"
If an error message with
button. This cancels the error message. You may then have to
reset the time. If the error is shown again, call the after-sales
service.
Error message
"‹‚‚
%
Possible cause
Defective fuse
Power cut
Type of heating not recognised
The oven is in demo mode.
Ÿ©
The ceiling and side parts in the
button,
cooking compartment are not self-
cleaning. The cleaning system
cannot be run.
Automatic switch-off has been
activated. The oven stops heating.
is shown in the display, press the
Possible cause
A button was pressed for too long
or has jammed.
Insert the uppermost panel and hold in place. The smooth
4.
surface must face outwards.
Put the cover back in place and screw it on.
5.
6.
Close the oven door.
Do not use the oven again until the panels have been
correctly fitted.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Note/remedy
Look in the fuse box and check that the circuit
breaker is in working order.
Reset the clock.
Make the settings again.
Switch off the circuit breaker in the fuse box, then
switch it back on after at least 20 seconds. Within
the next 2 minutes, press and hold the
for 4 seconds until the square disappears from the
display.
You can only set the cleaning system with the
button if you have retrofitted the self-cleaning ceil-
ing and side parts and activated the cleaning sys-
tem in the basic settings. See the Cleaning system
section and the Basic settings section.
Press any button.
You can take remedial action yourself if the following error
0
message is displayed.
Note/remedy
Press all buttons individually. Check that the but-
tons are clean. If the error message remains,
please contact the after-sales service.
h
button
s
17
Advertisement
Table of Contents
