Table of Contents
Advertisement
Cleaning the cooking compartment floor, ceiling and side
walls
Use a dish cloth and hot soapy water or a vinegar solution.
If there are heavy deposits of dirt, use a stainless steel scouring
pad or oven cleaner. Only use when the cooking compartment
is cold. Never treat the self-cleaning surfaces with a scouring
pad or oven cleaner.
Detaching and refitting the rails
The rails can be removed for cleaning. The oven must have
cooled down.
Detaching the rails
Lift up the front of the rail
1.
2.
and unhook it (figure A).
Then pull the whole rail forward
3.
and remove it (Fig. B).
4.
$
Clean the rails with cleaning agent and a sponge. For stubborn
deposits of dirt, use a brush.
Refitting the rails
1.
First insert the rail into the rear socket, press it to the back
slightly (figure A),
and then hook it into the front socket (figure B).
2.
$
The rails fit both the left and right sides. Ensure that, as shown
in figure B, levels 1 and 2 are below and levels 3, 4 and 5 are
above.
Folding down the grill element
:
You can fold down the grill element to clean the ceiling.
Risk of burns!
The oven must be cold.
Hold the grill element and pull the handle forwards until it
1.
clicks audibly in place (figure A).
Fold the grill element downwards (figure B).
2.
16
%
%
$
After cleaning, fold the grill element back up and hold it.
3.
4.
Pull the handle downwards until it clicks audibly into place.
Removing and installing the door panels
To facilitate cleaning, you can remove the glass panels from the
oven door.
When removing the inner panels, pay attention to the order in
which the panels are removed. In order to reassemble the
panels in the correct sequence, follow the number which
appears on each panel.
The oven door may open either to the left or to the right,
depending on the appliance model.
Removal and installation instructions for the door panels apply
to left and right-opening oven doors.
Removal
Open the oven door.
1.
2.
Unscrew the cover at the top of the oven door. To do this,
undo the left and right screws (fig. A). Hold the panel with
one hand.
Pull the top panel up and out (fig. B).
3.
$
4.
Unscrew the retaining clips on the right and left and remove
them (fig. C). Remove the middle panel.
&
Pull the lower panel diagonally upwards and out.
5.
Clean the panels with glass cleaner and a soft cloth.
Do not use sharp or abrasive materials or a glass scraper. This
may damage the glass.
%
%
Advertisement
Table of Contents
