Zyxel Device Access And Login - ZyXEL Communications VMG Series User Manual

If the problem continues, contact the vendor.
5

43.2 Zyxel Device Access and Login

I forgot the IP address for the Zyxel Device.
The default LAN IP address is 192.168.1.1.
1
If you changed the IP address and have forgotten it, you might get the IP address of the Zyxel Device by
2
looking up the IP address of the default gateway for your computer. To do this in most Windows
computers, click Start > Run, enter cmd, and then enter ipconfig. The IP address of the Default Gateway
might be the IP address of the Zyxel Device (it depends on the network), so enter this IP address in your
Internet browser.
If this does not work, you have to reset the device to its factory defaults. See
3
I forgot the password.
See the cover page for the default login names and associated passwords.
1
If those do not work, you have to reset the device to its factory defaults. See
2
I cannot see or access the Login screen in the web configurator.
Make sure you are using the correct IP address.
1
• The default IP address is 192.168.1.1.
• If you changed the IP address
• If you changed the IP address and have forgotten it, see the troubleshooting suggestions for
forgot the IP address for the Zyxel Device.
Check the hardware connections, and make sure the LEDs are behaving as expected. See
2
Figure 19 on page
Make sure your Internet browser does not block pop-up windows and has JavaScripts and Java
3
enabled.
If it is possible to log in from another interface, check the service control settings for HTTP and HTTPS
4
(Maintenance > Remote MGMT).
Reset the device to its factory defaults, and try to access the Zyxel Device with the default IP address.
5
See Section 1.4.5 on page
Chapter 43 Troubleshooting
(Section 8.2 on page
30.
55.
VMG/XMG Series User's Guide
185), use the new IP address.
382
Section 1.4.5 on page 55.
Section 1.4.5 on page 55.
I
Section