General Safety - Micromeritics ACCUPYC III Pre-Installation Instructions

General Safety

G S
ENERAL AFETY
Do not modify this instrument without the authorization of Micromeritics Service Per-
sonnel.
Any piece of laboratory equipment can become dangerous to personnel when improperly
operated or poorly maintained. All employees operating and maintaining Micromeritics
instruments should be familiar with its operation and should be thoroughly trained and instructed
on safety.
Read the operator manual for any special operational instructions for the instrument.
n
Know how the instrument functions and understand the operating processes.
n
Wear the appropriate personal protective equipment when operating this
n
instrument — such as eye protection, lab coat, protective gloves, etc.
When lifting or relocating the instrument, use proper lifting and transporting devices
n
for heavy instruments. Ensure that sufficient personnel are available to assist in
moving the instrument. The AccuPyc 1350 weighs approximately 11.5 kg (25.3 lb).
Always pay attention to the safety instructions provided on each label affixed to the
n
instrument and do not alter or remove the labels. When inspecting the instrument,
ensure that the safety labels have not become worn or damaged.
The AccuPyc III sound level is <65dBA from the operator's normal position, and
n
approximately 75dBA at 20 cm from the back of the instrument. Hearing protection
is optional.
Proper maintenance is critical to personnel safety and smooth instrument
n
operation and performance. Instruments require regular maintenance to help
promote safety, provide an optimum end test result, and to prevent costly down
time. Failure to practice proper maintenance procedures can lead to unsafe
conditions and shorten the life of the instrument.
n Improper handling, disposing of, or transporting potentially hazardous materials
can cause serious bodily harm or damage to the instrument. Always refer to the
SDS when handling hazardous materials. Safe operation and handling of the
instrument, supplies, and accessories are the responsibility of the operator.
If you have an ICD or pacemaker, avoid close or prolonged contact with magnets or
their magnetic fields. Keep magnets at least six inches from where your device is
implanted.
v
AccuPyc III Pre-installation Instructions and Checklist
135-42870-01 (Rev -) — Nov 2023