General Safety - Micromeritics FLEX Series Pre-Installation Instructions

General Safety

G S
ENERAL AFETY
Do not modify this instrument without the authorization of a Micromeritics service per-
sonnel.
Toxic or flammable gases require proper venting of exhaust.
Use caution in the areas where this symbol is displayed on the instrument — such as
the heating mantles and furnace. These surfaces may be hot and could cause serious
burns. Use the gloves supplied in the accessories kit.
Any piece of laboratory equipment can become dangerous to personnel when improperly
operated or poorly maintained. All employees operating and maintaining Micromeritics
instruments should be familiar with its operation and should be thoroughly trained and instructed
on safety.
Read the manual for any special operational instructions for the instrument.
n
Know how the instrument functions and understand the operating processes.
n
Wear the appropriate personal protective equipment when operating this instru-
n
ment — such as eye protection, lab coat, protective gloves, etc.
When lifting or relocating the instrument, use proper lifting and transporting devices
n
for heavy instruments. Ensure that sufficient personnel are available to assist in
moving the instrument. The Flex weighs approximately 103 - 106 kg (227 - 234 lb)
depending on configuration.
Always pay attention to the safety instructions provided on each label affixed to the
n
instrument and do not alter or remove the labels. When inspecting the instrument,
ensure that the safety labels have not become worn or damaged.
The Flex has a safety shield. Ensure it is in place when operating the instrument.
n
Proper maintenance is critical to personnel safety and smooth instrument oper-
n
ation and performance. Instruments require regular maintenance to help promote
safety, provide an optimum end test result, and to prevent costly down time. Failure
to practice proper maintenance procedures can lead to unsafe conditions and
shorten the life of the instrument.
Improper handling, disposing of, or transporting potentially hazardous materials
n
can cause serious bodily harm or damage the instrument. Always refer to the
MSDS when handling hazardous materials. Safe operation and handling of the
instrument, supplies, and accessories is the responsibility of the operator.
vi
Flex Series Pre-installation Instructions and Checklist
350-42870-01 (Rev H) — Apr 2021