Table of Contents
Advertisement
For the Australian/New Zealand market:
The circuit breaker incorporated in the fixed
connection must comply with AS/NZS 3000.
Section cut from the countertop
Safety instructions for positioning and
installation
See General safety instructions.
• Installation can be carried out on various
materials such as masonry, metal, solid
wood or plastic laminated wood as long as
they are heat resistant (>90°C).
• Veneers, adhesives or plastic coatings on
adjacent furniture should be temperature-
resistant (>90°C), otherwise they might
warp over time.
• If the piece of furniture does not have the
required recess opening, either it will have
to be cut or masonry work carried out by a
competent technician.
• The minimum clearance between exhaust
hoods and the cooking surface must be at
least the distance indicated in the exhaust
hood installation instructions.
• The minimum clearances must also be
respected for the edges of the hob on the
back as indicated in the assembly
instructions.
• If the appliance is to be installed above an
oven, the oven must be fitted with a cooling
fan.
Appliance overall dimensions (mm)
Models A 60 cm
Models B 72 cm
Models C 90 cm
16 - INSTALLATION
Minimum distance from combustible
surface
Hob
A: 200 mm (vertical combustible surface),
measured from the edge of the nearest burner.
B: at least 460 mm.
C: 600 mm (height), measured from the top of
the highest burner and 750 mm from an exhaust
fan.
D: 20 mm (worktop).
E: 50 mm (non-combustible surface).
X (width) & Y (depth) see the appliance
dimensions in this manual.
The maximum height from the upper part of the
pan support in relation to the surface that
supports the appliance is 47 mm.
Refer to AS/NZS 5601 (Protection of
combustible surfaces) if it is not possible
to meet the minimum distances
indicated above.
The supply connection point must be
accessible with the appliance installed.
Hob seal
To prevent leakage of liquid between the frame
of the hob and the countertop, place the
adhesive seal provided along the entire outer
edge of the hob before assembly.
L
600
720
900
Do not use silicone to secure the hob.
This would make it impossible to remove
the hob without damaging it.
91477A095/B
Advertisement
Table of Contents
